Home About Us Repair Center Technical Tips & Info In the Kitchen with Amy Contact Us
Filters/Filtration
Compressed Air
Vacuum
Vacuum Pump Parts
Steam
Pumps
Instrumentation
Process Equipment
Services
Valves
Boilers
Control Valves
Grundfos Pumps
Condensate Pumps
Tylok Fittings and Valves
Rotary Joints and Unions
Johnson Controls
Gearmotors
Industrial Automation
Air Knife Systems
CLOSE OUT - WAREHOUSE CLEARANCE SALE
Chainwheel Operators




 
Call Us. Email Us. Visit Us.


1.800.752.0556
770.532.7736

Contact Us Online


2503 Monroe Drive
Gainesville, GA 30507

 


Technical Tips & Information

Compressed Air Drain Trap Options

Worst A
A manual drain valve requires an operator to open the drain valve at the right time and for the correct duration to blow the water from the system. This system requires great diligence and an excellent memory! In most cases this system will also result in substantial air losses and water in your system.

Worst B
Timer operated blow down valves have been sold as an inexpensive method to blow water from systems. All you are required to do is set the duration of water blow and number of times per hour. Sounds simple. Assume the day you set the times, the humidity and air temperature were moderate. After some effort on your part, you get the duration and frequency just right with no wasted air but complete elimination of the water. Then the weather changes! If temperatures and humidity rise, you have water in your compressed air system. If the temperature and humidity drop, you blow compressed air. It is impossible to set timer blow down valves for reliable operation. Virtually all timer valves are set to over blow and not allow water in the system. That scenario can cost you over $600.00 per month in wasted air.

Good
A wide variety of adaptations of steam traps are offered by an assortment of manufacturers to drain water from air systems. If your water is clean and free of oils or aerosols, this type of air drain trap will do an acceptable job. Prices start at $94.00 for a bucket type trap and $98.00 for float operated traps. Consider use of mechanical traps for only clean applications to avoid much frustration.

Best
For high capacity applications such as receiver tanks, dryers, separators, and aftercoolers we suggest the Drain-All 1700. This is a float operated self powered drain unit which uses compressed air to drive an actuator which opens a full port 1/2” ball valve to eliminate the water from the separation device. The unit uses air power to eject the water, is self cleaning on every cycle, and operates automatically without maintenance of any kind. For high capacity applications this is the unit to choose. Most compressed air systems we visit have missing, ineffective, or non-operating drain traps.
»Back To Technical Tips