JD Gould Type Q Bronze Solenoid Valve
Out of stock
SKU
00000823
Product Shipping Subject to Factory Availability Need Specifications? See PDF Section Below.
JD Gould Type Q Bronze Solenoid Valve
General Specifications
2-Way - Cast Bronze Bodies - Packless
Velvetrol Internal Piston Pilot Operated Solenoid Valves
Normally Closed or Normally Open - Full Port
For: General Service air-inert gases-water-oil-steam
Pressure: 5 psi differential minimum to 400 psi maximum (300 psi max for normally open)
Temperature: -420F min to 450F max fluid
Mounting: Install in horizontal line with coil upright and on top
Sizing
1/8” - 3” NPTF Connections
Construction
Class F or N coils are waterproof, fungus proof, molded of filled polyester with 18” leads in NEMA 1 enclosures with 1/2” conduit connector.
Bodies are globe style, sand cast in bronze, and rated to 400 psi WOG.
Bonnet assemblies are 304 SS tubes silver soldered to brass bonnet and tube plug.
Piston assemblies contain brass SeatScrews in the brass Pistons with filled Teflon piston rings, stainless steel expanders, and Buna Seat Discs. Piston Springs are 316 or 302 SS. SeatScrew Assemblies are Buna Slugs in a brass SeatScrew, held in place with a brass Retainer.
Pilot Assemblies contain a 416 SS armature with a 316 SS pilot point and 316 SS pins.
Specials
EP, Viton and Teflon Leak-proof SeatScrews
EP, Viton, and Teflon Seat Discs Teflon
coated internal parts & other special assemblies available
Non-standard coils available with voltage, wattage, and lead wire length to your specifications. Coil enclosures meeting NEMA 4, 5, & 7
2-Way - Cast Bronze Bodies - Packless
Velvetrol Internal Piston Pilot Operated Solenoid Valves
Normally Closed or Normally Open - Full Port
For: General Service air-inert gases-water-oil-steam
Pressure: 5 psi differential minimum to 400 psi maximum (300 psi max for normally open)
Temperature: -420F min to 450F max fluid
Mounting: Install in horizontal line with coil upright and on top
Sizing
1/8” - 3” NPTF Connections
Construction
Class F or N coils are waterproof, fungus proof, molded of filled polyester with 18” leads in NEMA 1 enclosures with 1/2” conduit connector.
Bodies are globe style, sand cast in bronze, and rated to 400 psi WOG.
Bonnet assemblies are 304 SS tubes silver soldered to brass bonnet and tube plug.
Piston assemblies contain brass SeatScrews in the brass Pistons with filled Teflon piston rings, stainless steel expanders, and Buna Seat Discs. Piston Springs are 316 or 302 SS. SeatScrew Assemblies are Buna Slugs in a brass SeatScrew, held in place with a brass Retainer.
Pilot Assemblies contain a 416 SS armature with a 316 SS pilot point and 316 SS pins.
Specials
EP, Viton and Teflon Leak-proof SeatScrews
EP, Viton, and Teflon Seat Discs Teflon
coated internal parts & other special assemblies available
Non-standard coils available with voltage, wattage, and lead wire length to your specifications. Coil enclosures meeting NEMA 4, 5, & 7
Write Your Own Review