Watson McDaniel 1032 Inverted Bucket Traps
In stock
SKU
00001656
Product Shipping Subject to Factory Availability Need Specifications? See PDF Section Below.
Watson McDaniel 1032 Inverted Bucket Steam Traps are used in drip applications to remove condensate from steam mains and steam supply lines. For drip applications: the smaller sized units have adequate capacity. Discharge orifice of the inverted bucket trap is mounted at the top of the trap body, making them less susceptible to failure from dirt and debris. Not normally recommended for most process applications due to poor air-handling capability. However, they can be used on certain process applications such as unit heaters and laundry equipment, where discharging air during system start-up is not a critical factor.
Waterhammer resistant
Suitable for superheated steam
In-line repair ability is simplified by having all internals attached to the cover
Valve & Seat are located at the top pf the trap, making them less prone to clogging
All stainless steel internals with hardened valve & seat
Sizes: 1/2", 3/4", 1", 1-1/4", 1-1/2"
Connections: NPT
Need additional assistance? CONTACT US
TYPICAL APPLICATIONS
DRIP, TRACER, PROCESS: The IB Series inverted bucket traps are available in several sizes and capacity ranges. Inverted bucket traps can handle superheated steam when a check valve is used. The smaller traps are primarily used in drip and tracer applications. These traps are also used on unit heaters, laundry equipment, and other process equipment where slow start-up due to poor air handling capability can be tolerated. Larger sizes are used on process equipment; however, since bucket traps have limited air handling capability, F&T traps are the preferred choice.
DRIP, TRACER, PROCESS: The IB Series inverted bucket traps are available in several sizes and capacity ranges. Inverted bucket traps can handle superheated steam when a check valve is used. The smaller traps are primarily used in drip and tracer applications. These traps are also used on unit heaters, laundry equipment, and other process equipment where slow start-up due to poor air handling capability can be tolerated. Larger sizes are used on process equipment; however, since bucket traps have limited air handling capability, F&T traps are the preferred choice.
Write Your Own Review